Salsa Cycles Fargo Page

Thursday, December 13, 2012

The Day Of Dusting And Cleaning

Random dirty pic of my Fargo- Needs Cleaning!
Usually on Wednesdays I go riding and you might expect that I did just that because it was actually pretty nice out yesterday. But, I had some necessary domestic issues to attend to involving the water supply to the house.

Well, this meant that a long, long overdue dusting and cleaning of my work area needed to happen. I got busy in the morning with pecking away at the monster.

I actually made some headway before my lunch break, and with the results I was seeing, it spurred me on to get the deed done with plenty of time before the municipal "professional" came over to swap out the meter. That ended up leading to other issues, which ended up taking up the rest of my day. So, no further progress was realized in terms of cleaning the shop, or for taking care of my bicycles, for that matter.

My bicycles are due for some maintenance and cleaning too. Especially the gravel rigs. We had such a dry, dusty Summer and Fall that the dust is amazingly thick on frames and components. I'm sure there will be some drive train replacement parts entering the picture due to all of this as well. That's one thing about gravel riding- It is hard on the parts!

Gold Midge and new stem installed
One of the bikes due for some work in the drive train department is the Fargo Gen I. It already has seen some attention since the colder weather has settled in. I got a gold anodized Midge Bar and since that was a 31.8mm clamp diameter, the old stem went away and this Origin 8 UL stem went in its place.

This change also will mark a slightly lower front end position than I was using before, but since this bike is going all gravel all the time, I don't see it as an issue. I maybe came down a few millimeters, so it shouldn't be that big of a deal. Besides, the front end is pretty high on a Fargo Gen I as it is.

At this time, I could have swapped back to STI levers, but these Retroshifters are nice, and even though shifting from the drops is not possible, I am liking these better in every other way. They are staying on for the long term!

The drive train needs some attention though. I'll likely get a new cassette, chain, and maybe a different crankset. I may need a different bottom bracket as well, depending on the crank set chosen. If this crank stays it is getting a new, smaller drive ring. The one that is on it is 2 teeth too big for my tastes. Funny how only a two tooth difference can make a difference worth pursuing on a bicycle, but with this rig, I can say it is "fine tuning". I've had it long enough now that things are getting refined to a greater degree.

There is also the "Orange Crush" and the Gryphon to look after as well. Both dustier than all get out. The dusting and cleaning has only just begun, I am afraid!

3 comments:

  1. Cleaning my own bikes is something I don't look foward to. My Selma is a disaster after our last Iowa Mission. I am lucky to have found a portable heater that works after some testing. This will allow me to do some work in my garage, which is unheated. Still working on positioning on the Fargo Gen1.
    Ari

    ReplyDelete
  2. You are certainly correct about gravel riding being hard on the parts, bike or otherwise! So far the Vaya is holding up surprisingly well, but I have been cleaning it, including the drivetrain, fairly regularly. One thing I have noticed is that the gear cable layout (under the BB) is not proving the greatest for shifting smoothness. One place where your monster cross rig scores I guess.....

    I should probably not be admitting this, but I have actually made drivetrain changes in the past to realize a 1-tooth difference in chainring size.

    ReplyDelete
  3. I spent Sunday cleaning up my Mukluk from the Global Fatbike Day ride earlier in the month. Took a bit of time but it was needed maintenance.

    I also understand about that fine tuning of chainring sizes. I moved from a 46 to a 48 for my DK200 prep last spring and into early summer, but I opted to drop back down to a 46 for the race itself so that I spun a little faster and fatigued slower throughout the event.

    ReplyDelete